### COMPRESSION RATIO AND SQUISH

The compression ratio is a parameter of vital importance for the functioning of any engine; we will explain you in a few lines what it consists in, to better understand the engine functioning. The Tx compression ratio is calculated as follows:

Tx=  V+v                      V= displacement
v                        v= combustion chamber volume

It corresponds to the ratio between the sucked gas volume at disposal when the piston is in the low dead point and the sucked gas volume at disposal when the piston is in the high dead point. At equal displacements, to a higher volume of the compression ratio corresponds a combustion chamber with less value. It means that a high compression ratio value brings to higher pressures inside the combustion chamber therefore to a stronger thrust on the piston at the combustion time. Obviously everything has a limit and also in this case there are some values we must respect not to damage the engine; when the pressure of the air/petrol mixture oversteps this limit, the combustion is no more caused from the plug ignition spark but from a spontaneous and uncontrollable sparking caused from the high pressure and temperature, which could also bring to the fusion of the piston top. Another important value connected to the combustion chamber is the distance between the piston top at the high dead point and the combustion chamber edge. The gases turbulence there is in the combustion chamber is strictly connected with this value and exactly for the effect it has on the gases this distance is called “SQUISH”.

### TESTING OF THE COMPRESSION RATIO AND SQUISH MEASURE

These controls have big importance and to execute them, besides the usual workshop equipment, you need a buret with 0,1 cc graduations filled with anti-freezing fluid for radiators and a tin wire with 1 - 1,5 mm diameter. To measure the volume of the combustion chamber, position the engine with the cylinder in vertical position, bring the piston at the high dead point and fill the combustion chamber with the anti-freezing fluid through the plug hole until it reaches the plug thread, let the fluid left in the buret rest for a short time, read the volume value on the buret. This value is not to be used in the compression ratio calculation formula as it includes also the plug thread volume. To measure the plug thread volume disassemble the head, grease the bearing surface of the plug, lay it on a surface sufficiently smooth (marble, glass) and fill the plug thread with the fluid up to the internal edge of the combustion chamber. Subtracting this value from the one measured before you obtain the volume value of the combustion chamber, which can be included into the compression ratio formula.
Example (Scooter Zip Evolution 70cc):
Bore 47,6 mm = Displacement 69,93 cc
Stroke 39,3 mm
Volume complete with thread 7,4 cc